Product Type: HPRT Label Printer Mechanisms
Brand:HPRT
Product model:PT802(customizable)
Product package quantity:1
HPRT Label Printer Mechanisms PT802
描述
Model PT802
PRINTING CHARACTERISTICS
Print Method Direct line thermal
Resolution 8 dots/mm
Max. Printing Width 72mm
Number of Dots 576
Max. Printing Speed Max. 120 mm/s
MEDIA
Media Type Label/Receipt Paper
Paper Width Max. 84 mm
Paper Roll Inner Diameter 12.5mm or 40.5mm
Paper Roll Outside Diameter 120 mm
Media Total Thickness Max. 150um
DETECTION
Head TemperatureBy thermistor
Paper OutBy photo sensor
Platen OpenBy mechanical SW
Paper Taken NA
POWER SUPPLY
TPH Logic Voltage 3.0V-5.5V
Drive Voltage 24V±10%PEAK CURRENT
Head(Max.) 3.39A(24V/96dots)
Motor 750mA
RELIABILITY
Pulse Activation100 million
Abrasion Resistance 100KM
ENVIRONMENTAL
Operating Temperature0 – 50℃
PHYSICAL CHARACTERISTICS
Dimensions(W*D*H) 292.8*140*145mm
Mass 1629g
Precautions for use
1 The printer should be installed in a flat, stable place;
2 Avoid placing the printer in places with vibration and impact;
3 Leave enough space around the printer for operation and maintenance;
4 The printer should be away from water and avoid direct sunlight, strong light and heat sources;
5 Do not use and store the printer in places with high temperature, high humidity and serious pollution;
6 If you do not use the printer for a long time, disconnect the power supply of the printer.
7 The printer must not print in a paperless state, otherwise it will seriously damage the print head;
8 In order to ensure print quality and product life, it is recommended to use recommended or equivalent quality paper;
9 In the case of meeting the requirements of use, it is recommended to set a low level of printing concentration as far as possible, so as not to affect the service life of the print head;
10 Do not allow moist air condensation on the surface of the printer, if it has formed, do not turn on the power of the printer before the dew is eliminated;
11 Avoid water or conductive substances (such as metal) entering the printer, once it occurs, the power should be turned off immediately;
12 When plugging or disconnecting each interface, the power supply must be turned off, otherwise it may cause damage to the printer control circuit;
13 Do not disassemble the printer for maintenance.
